Renovation, construction, finishing work

Socket installation includes cutting power, preparing the wires and connecting them properly to the terminals. Mistakes can cause a short circuit or fire, so this work is best handled by a specialist.

Yes, if you have basic knowledge and follow safety rules. But if you have any doubts at all, it is better to call a professional because the task is inexpensive but still safety-critical.

Typical signs are tripping breakers, hot sockets, old aluminum wiring, sparks or a burning smell. In these cases replacement should not be postponed.

The price depends on the floor area, number of points and the complexity of the work. It can range from simple budget solutions to a full turnkey replacement. An exact quote is possible after inspection.

Sockets should be located near the appliances: refrigerator, stove, kettle and microwave. It is important to plan enough outlets in advance so extension cords are not needed later.

At least 4 to 6, but usually more is better for a TV, chargers and lighting. Modern apartments typically need more sockets than older layouts provided.

The wires are laid into wall chases and then covered with plaster. It is a dusty and technically demanding job that requires proper tools and experience.

Remove the old finish, level the surface, apply filler and primer. Without proper preparation the paint will not sit evenly.

Yes. Primer improves adhesion and reduces paint consumption.

Filler is usually applied in several coats with sanding between coats. It is important to control both flatness and layer thickness.

Pour the powder into water, not the other way around, and mix it with a mixer. The correct proportions also matter.

Usually 2 or 3 coats: a base coat and a finish coat. The exact number depends on the condition of the walls.

Major unevenness is corrected with plaster, while smaller defects are handled with filler. In some cases drywall systems are used.

Paint looks modern and is easy to refresh later. Wallpaper hides small defects more easily. The right choice depends on budget and goals.

The base must be level, and you need a level tool plus tile spacers. Without experience it is difficult to achieve a truly clean result.

Look at moisture resistance, slip resistance and durability.

A tile cutter or a suitable specialist tool is used. Without it, the material is easy to ruin.

The price depends on tile size, layout complexity and base preparation. It is usually calculated per square meter.

Remove the old adhesive, clean the surface and glue the tile again. If many tiles are failing, the area likely needs a larger rework.

Laminate feels warmer and cozier, while tile is more durable and moisture-resistant. A combination of both is often the best solution.

It is laid on an even base with underlay and an expansion gap along the walls. If the method is wrong, the floor can swell later.

Yes. Unevenness can cause squeaks and lead to damage.

The reason is usually an uneven base or poor installation. Partial or full repair may be required.

There are electric and water-based systems. The right choice depends on the room and the budget.

It requires precise connection to the drain and proper sealing. Mistakes can cause leaks.

Shut off the water, remove the old faucet and install the new one with proper sealing. The job is not difficult, but it requires accuracy.

Most often the seals or cartridge are worn out. Those parts need replacement.

Household products can help with small clogs, but serious blockages usually require a professional.

It depends on the volume of work and the chosen equipment. The price is calculated individually.

Start with a plan and a budget. It is important to think through all phases in advance.

Rough work comes first, then finishing: walls, floor and ceiling.

Yes, but some materials and temperature conditions create limitations.

The price depends on the condition of the apartment and the expected scope. It is calculated after inspection.

Look at experience, reviews, contract terms and warranty.

Choose the right fixings for the wall type and mark the holes accurately before drilling.

Use the right drill bit and avoid pushing too hard.

Clean it, apply primer and fill it with filler.

Wet it with water or a special solution and then remove it with a scraper.

Use a good roller and apply the paint evenly in several coats.